Manual glue gun use method

1. Prepare tools and equipment, a word screwdriver, a bottle of sealant, a glue gun.  

2. Use a word screwdriver to gently insert the glue head of the sealant into a small mouth, so that the sealant can flow out.  

3. Insert the small iron cover of the sealant into a small opening with a one-word screwdriver, and then gently remove the small cover, as shown in Figure 2.  

4. Screw the glue nozzle clockwise on the sealant head through the thread of the sealant head.  

5. Put the black fixing ring of the glue gun at the end of the glue gun, the purpose of doing this is to make the sealant inserted into the glue gun smoothly.  

6. Hold the small spring of the glue gun with one hand, and adjust the elongation arm of the glue gun to the maximum with the other hand. The purpose of doing this is to make the sealant can all enter the inside of the glue gun.  

7. Start with the glue gun from the tail and insert it into the glue gun bit by bit. When only the glue mouth is exposed, the whole sealant has been inserted into the glue gun.  

8. The black fixing ring of the glue gun is put on the head of the glue gun. The purpose of doing this is to make the sealant can be fixed inside the glue gun and prevent the sealant from being removed from the glue gun when the glue gun is used.  

9. Press the small spring at the end of the glue gun again, and push the extended arm of the glue gun forward with the other hand until it can't be pushed.